qnap surveillance station video generic camera

My settings in Surveillance Station are set to camera motion detection. This forum has been a lifesaver for me as always, any help or advice is greatly appreciated!!ĮDIT: I am using motion detection through the camera, not the surveillance station. I'm using the camera configuration file (nf) from this thread: One camera bought as Hikvision DS-2CD2132-I, (and comes up as NC-KD032,)įirmware: V5.0.2 130805, encoding ver V4.0 build 130411. Synology Surveillance Station 6, running on DSM 4.2 build 3202 Here's some more info about my setup in case it's helpful: I thought I read over at that the Synology box takes control of certain settings on the Hikvisions, ( ) I renamed the cameras (from Syno) and I'm still having this problem. All my cameras motion detection configs reset at the same time (both the DS-2CD2032-I, and the DS-2CD2132-Is.) I have them connected to a Synology DSM running ver 4.2. Reduce the seconds or disable it to improve the video buffering problem. Please check the 'Liveview -> Advanced -> Enable video buffering' option in the camera editor. This is expected to have better compatibility than ONVIF or User Define.

And they record loads and loads when there is no activity to speak of. I think Jason was referring to the GenericHIKVISION function. Once in a while, my Cameras' motion detection settings get reset back to default, where the entire view is selected, and the sensitivity setting is at or near max (instead of my settings where only part of the view is selected and the sensitivity is set to the middle.) I realize sometime after this happens because my cameras start recording when there is 'no' motion.

Qnap surveillance station video generic camera